Vertical jump tests: which to use and how to run them
Four tests, what each one tells you, and the details that change the number.
Last updated 17 November 2026
Countermovement jump: slow stretch-shortening cycle. Squat jump: concentric only. Drop jump and hop test: fast, reactive.
An arm swing added 8.6 cm in one study, about three quarters of it from a faster take-off (Lees et al., 2004). Hands on hips, or arms, never a mix.
Cueing height or speed alone gave very different contact times from the same box. Use the same words every session.
Every test varies from jump to jump. Know by how much before you read a change into a result.
The tests
Countermovement jump
A countermovement into a maximal jump. Time to take-off is well over 250 ms, so it reflects the slow stretch-shortening cycle. The most widely used jump test, and the one most often tracked week to week.
- Use for
- Profiling, and monitoring fatigue and adaptation
Squat jump
A maximal jump from a held squat, with no countermovement, so it isolates the concentric phase. Run on the same day as a countermovement jump, the ratio of the two shows how much the countermovement adds. A bigger gap is not automatically better: it can also mean the athlete is poor at building force from a static start (Van Hooren and Zolotarjova, 2017).
- Use for
- Concentric ability, and the comparison with the countermovement jump
Drop jump
A rebound from a box. It tests reactive strength under a set landing load. With contact under about 250 ms it reflects the fast stretch-shortening cycle.
- Use for
- Reactive strength
Hop test
Continuous rebounds with no box, usually ten after a lead-in jump. Also called the 10/5 repeated jump test. Reactive strength from repeated short contacts.
- Use for
- Reactive strength without a box, and quick squad testing
The countermovement jump, drop jump and hop test can also be run on one leg, to compare left with right.
What each test gives you
| Test | Jump height | Contact time | Reactive strength index | Contraction time | RSI-modified | Countermovement depth | Eccentric utilisation ratio |
|---|---|---|---|---|---|---|---|
| Countermovement jumpSlow stretch-shortening cycle | |||||||
| Squat jumpConcentric only | |||||||
| Drop jumpFast stretch-shortening cycle, from a box | |||||||
| Hop testFast stretch-shortening cycle, repeated |
YesNeeds both tests on the same dayNo
Reactive strength index is reported two ways: flight time divided by contact time, or jump height divided by contact time. They are different numbers, so note which one your device gives you.
How to run them
Countermovement jump
- Hands on hips. Stand tall, feet hip to shoulder width apart, looking forward.
- Stand completely still for two to three seconds.
- Dip without rising onto the toes first, and jump straight up in one movement.
- Touch down with legs extended, as at take-off, then absorb the landing and stand still.
Three jumps is standard.
Squat jump
- Hands on hips. Stand tall and still.
- Sink into a squat: about a quarter squat, or 90° at the knee. Use the same depth every time.
- Hold completely still for two to three seconds.
- Jump straight up from the hold, with no dip first.
- Touch down with legs extended, then absorb the landing and stand still.
Three jumps is standard.
Drop jump
- Set the box immediately behind the landing spot. Studies use 20 to 50 cm. Pick one height and keep it.
- Stand tall on the box, hands on hips.
- Step off. Do not jump off or lower yourself first: either one changes the fall height.
- Land on both feet at the same time and jump straight back up.
- Absorb the final landing and stand still for two to three seconds.
Three jumps is standard.
Hop test
- Hands on hips. Stand tall and completely still for two to three seconds.
- Dip and jump once. This first jump is not scored.
- Land stiff-legged on the balls of the feet and spring straight back up, knees as straight as possible.
- Keep hopping on the same spot with no pause.
- Absorb the last landing and stand still.
Ten hops after the first jump is standard. The score is the average of the five best hops by reactive strength index.
Steps are based on the published ForceDecks and Hawkin Dynamics test instructions. On the countermovement jump, a shallower dip than the athlete would choose tends to lower jump height and raise RSI-modified (Pérez-Castilla et al., 2021), so watch the depth and keep it consistent.
Taking the score
A meta-analysis of 151 studies found the average countermovement jump height more sensitive than the best jump for picking up fatigue and adaptation (Claudino et al., 2017).
Drop jump reactive strength index varied by about 2 to 3 % within a session in professional basketball players (Markwick et al., 2015), and one set was enough for the hop test (Stratford et al., 2021).
Same warm-up, arm position, cue, box height, device and point in the session. Then a change bigger than the test’s normal jump-to-jump variation is worth acting on.
For what a typical result looks like by age, sex, sport and level, see the normative data.
How to measure vertical jump height
From flight time
Time in the air, converted to height. It assumes the athlete touches down in the position they took off in. Bent knees or ankles at touchdown lengthen the flight and inflate the height: a 20° change at the ankle added about 8 % to a 30 cm jump in a modelling study (Gonçalves et al., 2024). On a countermovement jump it usually reads a few centimetres higher than the take-off velocity method.
- Used by
- Contact mats, photocells, phone apps, and force plates as an option
From take-off velocity
Height calculated from the body’s upward velocity at take-off. On a force plate this is the impulse-momentum method. The landing does not affect it, which is why a 2023 systematic review recommends it where it is available (Xu et al., 2023).
- Used by
- Force plates. Metra Performance has it in beta for the countermovement jump
The two are different numbers, so record which one you use and do not mix them. For the devices themselves, see the device comparison.
Metra Performance
An iPhone app that runs these tests from a tripod and shows each result live. No cloud processing, no calibration, no manual frame picking, no wearables.
- Tests: countermovement jump, drop jump and hop test, hands on hips. Squat jump, single-leg tests and loaded jump are in beta.
- Measures: jump height (flight time), flight time, contact time, reactive strength index, contraction time, RSI-modified and countermovement depth.
Our own testing against force plates, with hands on hips. It is not yet peer reviewed; a study is in preparation. Every measure, with its jump count, is in the validation summary.
More: Metrics calculator · Device comparison · Normative data · Metric definitions · Validation summary
Sources
- Claudino, J. G., et al. (2017). The countermovement jump to monitor neuromuscular status: A meta-analysis. Journal of Science and Medicine in Sport, 20(4), 397–402. doi.org/10.1016/j.jsams.2016.08.011
- Gonçalves, C., et al. (2024). Error in jump height estimation using the flight time method. PeerJ, 12, e17704. doi.org/10.7717/peerj.17704
- Hawkin Dynamics. Test protocols. learning.hawkindynamics.com/knowledge/test-protocols
- Lees, A., Vanrenterghem, J., & De Clercq, D. (2004). Understanding how an arm swing enhances performance in the vertical jump. Journal of Biomechanics, 37(12), 1929–1940. doi.org/10.1016/j.jbiomech.2004.02.021
- Louder, T., Bressel, M., & Bressel, E. (2015). The kinetic specificity of plyometric training: Verbal cues revisited. Journal of Human Kinetics, 49, 201–208. pubmed.ncbi.nlm.nih.gov/26839620
- Markwick, W. J., et al. (2015). The intraday reliability of the reactive strength index calculated from a drop jump in professional men’s basketball. International Journal of Sports Physiology and Performance, 10(4), 482–488. doi.org/10.1123/ijspp.2014-0265
- Pérez-Castilla, A., et al. (2021). Vertical jump performance is affected by the velocity and depth of the countermovement. Sports Biomechanics, 20(8), 1015–1030. doi.org/10.1080/14763141.2019.1641545
- Sánchez-Sixto, A., McMahon, J. J., & Floría, P. (2021). Verbal instructions affect reactive strength index modified and time-series waveforms in basketball players. Sports Biomechanics. doi.org/10.1080/14763141.2020.1836252
- Sheppard, J. M., & Doyle, T. L. A. (2008). Increasing compliance to instructions in the squat jump. Journal of Strength and Conditioning Research, 22(2), 648–651.
- Stratford, C., Dos’Santos, T., & McMahon, J. J. (2021). The 10/5 repeated jumps test: Are 10 repetitions and three trials necessary? Biomechanics, 1(1), 1–14. doi.org/10.3390/biomechanics1010001
- VALD. ForceDecks test protocols. support.vald.com
- Van Hooren, B., & Zolotarjova, J. (2017). The difference between countermovement and squat jump performances: A review of underlying mechanisms with practical applications. Journal of Strength and Conditioning Research, 31(7), 2011–2020. doi.org/10.1519/JSC.0000000000001913
- Xu, J., et al. (2023). A systematic review of the different calculation methods for measuring jump height during the countermovement and drop jump tests. Sports Medicine, 53(5), 1055–1072. doi.org/10.1007/s40279-023-01828-x